Do you have a easy-to-understand guide that would let us setup Ipv6 so we could ping and visit IPv6 sites as well as issue our computers IPv6 LAN addresses?
I found some stuff on the DD-wrt wiki and IPv6 but couldnt make heads or tails of much of it and couldnt get it to work.
I see the option of enableing IPv6 under Administration Mangement but it looks like its more complicated then just a bubble and reboot....
My current provider does not yet support IPV6, therefore I cannot test IPV6.
Once more and more providers switch to IPV6 you will quickly see foolproof IPV6 setup in dd-wrt.
Well, I use sixxs.net as my IPv6 provider/tunnel and it works ok with Kong 18050 (nv60k with miniDLNA) on Linksys E3000.
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2011 NETGEAR, Inc. All rights reserved.
Did you forget your password?
You can also log in using OpenID.
