hej everybody.
i've installed the usb/ftp/minidlna/samba3 firmware and enabled vpn, usb-support, dlna, ftp and samba.
when i connect my cremax icy dock mb561us-4sbc-1 (it's an multibay case for 4 hdds) only the first hdd gets recognized and mounted.
when i try to navigate down the folders from /dev/scsi/ i only can find:
/dev/scsi/host0/bus0/target0/lun0/part1
when i try to insert the hdds one by one no hdd gets mounted and the disk info looks very strange.
has anybody an idea?
This device uses a port multipliercard that is only supported in the latest linux kernels. The kernel however cannot be updated unless broadcom delivers new drivers that work with a recent linux kernel. Therefore the current kernel only sees one drive.
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2011 NETGEAR, Inc. All rights reserved.
Did you forget your password?
You can also log in using OpenID.
