Previous Thread
Unlikely.
I will check this again, WGR614v4 is a Marvell SoC based router and if you check its source code, it is eCoS based. It also has too little flash/sdram (1MB/8MB) for running tomato.
-Nachi
Categories: WGR614L Open Source Router
Is it possible to load the tomato load onto a wgr614 v4. It seems to have the same base Broadcom chipset, but the load is refused by the router. Does anyone know if this is possible? I would think this is similar enough that it ought to work. I'm trying to turn this device into a wireless client.
NETGEAR
- member since: 12/13/2007
- rank: 5 of 822
- 1 articles authored
- 4 blog entries posted
- 3 forum threads started
- 59 comments
March 4, 2008 10:58 AM
NETGEAR
- member since: 12/13/2007
- rank: 5 of 822
- 1 articles authored
- 4 blog entries posted
- 3 forum threads started
- 59 comments
March 5, 2008 10:17 PM
You should use the WGR614L for running the tomato firmware.
WGR614v4 cannot run the tomato firmware since it is a Marvell based platform and it has too low a memory to run most of the replacement firmwares like openwrt, dd-wrt and tomato.
Add Your Reply
Sponsored Links
Copyright © 2008
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
Drobo Space |
DVR playground |
MediaSmart Home |
Monster Community |
MotoDash |
My DigitalEntertainer |
My Open Router |
Presto Place |
Robo Community |
Sansa Community |
Sling Community |
TechLore |
TiVo Community
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2008 NETGEAR, Inc. All rights reserved.
