Previous Thread
Categories: WGR614L Open Source Router
I have a WGR614v8 and I was able to locate and use the UART0. Now I need to know if there is a way to use the second UART, the UART1. I don't see any header on the board for it. Could it be shared with the JTAG pins or the GPIO ?
In case that is not possible to use the UART1 in this hardware, can you suggest a model that can ?
Add Your Reply
Sponsored Links
Copyright © 2008
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
Drobo Space |
DVR playground |
MediaSmart Home |
Monster Community |
MotoDash |
My DigitalEntertainer |
My Open Router |
Presto Place |
Robo Community |
Sansa Community |
Sling Community |
TechLore |
TiVo Community |
TouchSmart Community
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2008 NETGEAR, Inc. All rights reserved.
