Eko said: Wiki is your friend: http://www.dd-wrt.com/wiki/index.php/Repeater_Bridge

Hi ,

Thnks for the reply but I am not yet able to configure my router as a repeater bridge.

I went through the above link and tried to do the set  up as follows :

My primary router is connected to a 192.168.10.X network with AP mode enabled . I am using D-Link WBR-2310

as my primary router . I have connected the WAN port of my primary router to LAN .

For secondary router I have given it an IP 192.168.10.203 and rest parameters as given in the above link .

Now if I connect a PC to the secondary router through its LAN port and try to access net or even ping primary router ,

I am not able to do this .

Could any one please tell me if my setup is OK or where am I missing .

Thanks in advance,