Previous Thread
Sorry, I don't have any board of AT91SAM9261. So can not comment on this now.
I think this is ARM processor. If you can give some more input about your problem then somebody may help you.
Which portion of the firmware is taking time ?
Categories: Open Source Projects and Firmware
HI all,
when im booting my Jffs2 filesystem image on my target board of AT91SAM9261 atmel board with the linux kernel image ..im getting these message which is causing my jffs2 to load slowly..
JFFS2 notice: (721) check_node_data: wrong data CRC in data node at 0x056fe800: read 0xa35d5792, calculated 0xd7b5d1a5.
JFFS2 notice: (721) check_node_data: wrong data CRC in data node at 0x06260800: read 0xa5369999, calculated 0x6deda12a.
NETGEAR
- member since: 12/24/2007
- rank: 6 of 30039
- 5 articles authored
- 4 blog entries posted
- 21 forum threads started
- 788 comments
December 10, 2008 10:59 PM
December 11, 2008 12:06 AM
yeah this is ARM processor. The loading of the filesystem is taking a lot of time.
im using a linux kernel , and a jffs2 file system for my Nand flash memory . If u want any more inputs let me kmow . does anybody has faced a similar problem?
warm regards,
Ravi Kulkarni
Add Your Reply
Sponsored Links
Copyright © 2013
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
My Open Router |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2011 NETGEAR, Inc. All rights reserved.
