Hi all,

I have build a DD-WRT firmware and flashed my WGR614L with it . With this f/w the board boots OK .... the problem is that with this f/w factory hard reset does no work properly and whenever I do a factory hard reset the boot fails with the following error message :

CFE for WGR614v8 version: 1.3
Build Date: Fri Apr 20 14:04:44 CST 2007
et0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 4.138.1.0
Committing NVRAM...done


CFE for WGR614v8 version: 1.3
Build Date: Fri Apr 20 14:04:44 CST 2007
et0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 4.138.1.0
Device eth0:  hwaddr 00-1E-2A-07-AC-8A, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
Loading .................................
Image chksum: 0x0DE968E6
Calc  chksum: 0x8F3666A7
Loader:raw Filesys:raw Dev:flash0.os File: Options:(null)
Loading: . 0 bytes read
Failed.
Could not load flash0.os:: Error
CFE>

Now subsequently if I again flash the router with my DD-WRT f/w using tftpd ... the boot happens properly and all things become OK ....

Problem arises whenever I try to do a reset .... It seems there is some mistake .....

Could anyone plz provide me with some ideas in this regard ....

thnx in advnc ....