Previous Thread
you can have a look at the following thread:
http://www.myopenrouter.com/forum/thread/11652/WGR614L-s-LED-behavior-in-Tomato/
Categories: WGR614L (Legacy Product)
So,
i flashed tomato v1.23 to my wgr614v8 all works fine.
but the wireless led is off and the led with the "check" is always on (orange)
does someone know how to fix it ?
and second question is it possible to led the netgear work as repeater bridge (means connect via wireless and via lan to the netgear and the netgear connects via wireless to the host-router )
greets
Member
- member since: 10/14/2008
- rank: 120 of 6271
- 4 articles authored
- 16 forum threads started
- 406 comments
July 2, 2009 11:15 PM
NETGEAR
- member since: 12/24/2007
- rank: 1 of 6271
- 4 articles authored
- 4 blog entries posted
- 6 forum threads started
- 536 comments
July 3, 2009 12:15 AM
It should be possible to configure Netgear board as repeater bridge. People already configured it as repeater bridge with other firmware like DD-WRT and OpenWRT.
Add Your Reply
Sponsored Links
Copyright © 2010
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My DigitalEntertainer |
My Open Router |
Pogoplugged |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2008 NETGEAR, Inc. All rights reserved.
