Previous Thread
This should not happen. Tell me whether wireless LED is on or off.
By default this wirless setting is enabled. I do not know why it is showing disable state in your case. You can reset factory setting also.
My advice you to try with newer version of Tomato (1.25) which is already available in this site.
Categories: WGR614L (Legacy Product)
I installed Tomato v1.23 to my NetGear WGR614L. The wired routing features all seem to work correctly. But every time I enable wireless from the Administration screen, there is a 10-second "Please wait" count-down, but it goes back to Disabled state. And when I try to connect to it from my laptop, the SSID is not visible. I've set up the wireless configuration items using exactly the same values as with my previous router. The wireless worked correctly on this router when I was running the original NetGear firmware. Any suggestions on what to try?
Paul McJones
NETGEAR
- member since: 12/24/2007
- rank: 6 of 28504
- 4 articles authored
- 4 blog entries posted
- 16 forum threads started
- 687 comments
July 6, 2009 12:09 AM
July 6, 2009 10:25 AM
The wireless LED does not come on.
I would be happy to try Tomato version 1.5. But when I downloaded the file http://www.myopenrouter.com/download/11490/Tomato-1.25-Firmware-Source-Code-f... it appeared this only includes the source code and tools, but not the compiled code. I don't currently have the time to set up a build environment -- is there a precompiled version available for downloading?
Also, to revert to the factory firmware, is it possible to use the Tomato's web interface firmeware upgrade feature to install the .CHK file version of the original Netgear firmware?
Thank you very much for your help.
Paul McJones
NETGEAR
- member since: 12/24/2007
- rank: 6 of 28504
- 4 articles authored
- 4 blog entries posted
- 16 forum threads started
- 687 comments
July 6, 2009 11:39 PM
Compiling the firmware would not much time. Again if your machine's processor is slow then it could some amount of time :) To set up the build environment you need a Linux PC only.
In the meantime I will try to upload the pre-built firmware in this site.
At this moment there is no pre-built firmware (Tomato 1.25) available in this site.
Yes, it is possible to revert back to Original Netgear firmware through web upgrade feature of Tomato.
Add Your Reply
Sponsored Links
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2011 NETGEAR, Inc. All rights reserved.
