Previous Thread
Which mode in WAN are you using -- Static , Dynamic or PPPoE? I will test the firmware again, most probably SSH and Telnet are not running on the board. However you can enable them in configuration file and prepare one new firmware.
Hello
I installed openwrt on my WGR614L v8, get well
GUI
The wifi works well
DHCP works well
Test ping 192.168.1.1 Ok
Do not work
No WAN
No SSH
No Telnet
My lights are green and orange
I can load the firmware from fedora 11 or Vista pro
Could you tell me walked the tack, its very important
Thank you for your help
NETGEAR
- member since: 12/24/2007
- rank: 8 of 27821
- 4 articles authored
- 4 blog entries posted
- 12 forum threads started
- 640 comments
November 5, 2009 10:58 PM
December 13, 2009 4:28 AM
On my router I had to change the WAN interface in /etc/config/network from eth0.0 to eth0. But you might need a serial cable to make that change.
NETGEAR
- member since: 12/24/2007
- rank: 8 of 27821
- 4 articles authored
- 4 blog entries posted
- 12 forum threads started
- 640 comments
Add Your Reply
Sponsored Links
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2011 NETGEAR, Inc. All rights reserved.
