Previous Thread
What release version did you use on DD-DRT? Some early releases had some problems.
Yesterday I've tried to enable SSHd in DD-WRT. The router rebooted but does not come up. It hang up. The power LED was orange but not flashing. I could see that an ethernet device was connected but it was no longer possible to ping or access the router. It looked like death.
I already thought that the router was bricked. I did a 30/30/30 reset of DD-WRT. After this the router successfully booted again.
Any ideas?
Moderator
- member since: 01/23/2008
- rank: 2 of 6271
- 15 articles authored
- 8 forum threads started
- 265 comments
January 5, 2010 8:07 PM
January 6, 2010 1:42 AM
I got an answer from DD-WRT forum that it was because to less available NVRAM. I had enabled OpenVPN and I was told that it use much amount of NVRAM. May be this is / was the issue. Since I have reset the router, I haven't enabled OpenVPN again since this, but I haven't tried to enable SSHd since that.
January 20, 2010 4:05 AM
I had the same issue when moving from svn13401-std-ftp-usb to svn 13309-big.
Each and every changing to NVRAM caused the same problem that you described.
I had to reset the NVRAM and reconfigure everything manually.
Add Your Reply
Sponsored Links
Copyright © 2010
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My DigitalEntertainer |
My Open Router |
Pogoplugged |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2008 NETGEAR, Inc. All rights reserved.
