Previous Thread
Did you try the WAN port?
Might be worth trying the hard reset covered here.
I just installed tomato and couldn't get WAN to work.
So I tried setting the type to 'Disabled' and then 'Use the WAN port for LAN'. Now I can't connect to the router through LAN or WLAN. I've tried holding the reset button for 10, 20, 30, 40+ seconds. Didn't work. What can I do?
Member
- member since: 02/28/2010
- rank: 5 of 28504
- 1 articles authored
- 27 forum threads started
- 1023 comments
April 19, 2010 5:24 PM
When your router is on, press 30s, while pressing the reset button, turn off power, still holwing the reset button, after 30s power on keep on pressing the reset utton for another 30s.
NETGEAR
- member since: 12/24/2007
- rank: 6 of 28504
- 4 articles authored
- 4 blog entries posted
- 16 forum threads started
- 687 comments
Add Your Reply
Sponsored Links
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2011 NETGEAR, Inc. All rights reserved.
