Previous Thread
Your router is not bricked yet but waiting for the firmware. You will need to tftp to the router to get it going again. See the following post by taekwon3dan....
This is what I did going from tomato 9047 to Netgear 1.0.2.50. After a 30-30-30, I simply upgraded to Netgear 1.0.2.50 in chk format. It took, but the power light keeps blinking.
At this point, I power cycled (30 sec), did 30-30-30, and then tftp'd to 192.168.1.1 [ tftp -i 192.168.1.1 put filename]
Wait 5 minutes, power cycle, 30-30-30...VOILA.
IN MY EXPERIENCE, IT IS IMPORTANT THAT YOU SET A STATIC IP ON YOUR PC WHEN PLAYING AROUND WITH ROUTER FIRMWARE UPGRADES!!
Go to this link for instructions on how to tftp. You can skip the first part and go to installing the tftp client after router reboot.
http://www.myopenrouter.com/article/16099/How-To-Reflash-Factory-Firmware-on-...
Categories: Troubleshooting
Hello,
after installing DD-WRT and TomatoUSB without any problem, i tried to restore my WNR3500L with an orignal firmware. (WNR3500L-V1.0.0.74_12.0.64NA.chk).
After flashing firmware, i got my green power led blinking ...
I tried hard reset : No way !
Is my router bricked ?
What's the solutions ?
Thx.
Add Your Reply
Sponsored Links
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2011 NETGEAR, Inc. All rights reserved.
