I flashed my Netgear WNR3500L from the stock firmware to Tomato via DD-WRT. I didn't do a hard-rest after DD-WRT was flashed (the tutorial suggested doing a hard-reset). Instead, I flashed Tomato directly upon the freshly DD-WRT, and I didn't do anything on DD-WRT except flash Tomato. Will there be any problem?
Another question: does the "erase NVRAM" option of Tomato has the same effect as a 30-30-30 reset?
Thanks.
August 11, 2011 11:54 PM
In 30-30-30 reset mainly default nvram parameters are reloaded by bootloader. Now as DD-WRT and Tomato both uses those nvram parameter in their own way so there is a possiblity of malfunctioning. Its better to go as per the tutorial.
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2011 NETGEAR, Inc. All rights reserved.
Did you forget your password?
You can also log in using OpenID.
Previous Thread
