OUR NETWORK:TiVo Community TechLore Explore3DTV DVRplayground Dijit Community See all... About UsAdvertiseContact Us
Previous Thread | Next Thread

 
Learn about scoring Forum's Raw Score: 116487.0
February 5, 2011 11:46 AM

Categories: Setup / Configuration

Rating (0 votes)
  • 1
  • 2
  • 3
  • 4
  • 5
Rate This!

Member Avatar

m4p

Member
Joined: 01/31/2011

I'm looking to test my wireless speed on my WNR3500L.  Is there an easy way to test it or freeware program that is not complicated?  Thanks.

Discussion:    Add a Comment | Comments 1-3 of 3 | Latest Comment

jmccrohan Avatar
Member
  • member since: 08/06/2010
  • rank: 23199 of 28504
  • 8 comments
February 7, 2011 1:22 PM

Try using iperf.

m4p Avatar
Member
February 7, 2011 4:24 PM

Thanks, I did try jperf/iperf and I'm embarrassed to say this, but I couldn't figure it out. I went into my attached devices list while streaming from my computer to my bluray player and found the IP for the bluray player. But I'm not sure how to configure jperf. Would the bluray player be Client Server and if so, what port (I use a software DLNA server that uses port 1900). I check UDP for protocol but not sure if that's right.

jmccrohan Avatar
Member
  • member since: 08/06/2010
  • rank: 23199 of 28504
  • 8 comments
February 7, 2011 4:28 PM

You need to run iperf on both the client and the server.

Run "iperf -s" on the server, and run "iperf -c serveraddress" on the client. :)

Discussion:    Add a Comment | Comments 1-3 of 3 | Latest Comment

Add Your Reply

(will not be displayed)

Email me when comments are added to this thread

 
 

Please log in or register to participate in this community!

Log In

Remember

Not a member? Sign up!

Did you forget your password?

You can also log in using OpenID.

close this window
close this window