Previous Thread
Hi Jason, I already replied to your PM (and got your response back) but I wanted to post the link I sent you to everybody:
http://adafruit.com/datasheets/DS_TTL-232R_CABLES_V201.pdf
Categories: Troubleshooting
I have bricked my Netgear WNR3500L by installing the wrong firmware onto it. I've been using a basic router in the mean time, but I really need to get my Netgear working again.
I have bought a USB-TTL serial adaptor from eBay, but I am not sure which pins to use on the router's header pins.
This guide assumes that a particular cable is being used: http://www.myopenrouter.com/article...AR-WNR3500L-Using-A-USB-TTL-Cable-on-Windows/
My USB-TTL adaptor has the following pin layout:
Could anybody tell me which pins I need to use and which pins I need to connect to on the router's serial header?
Administrator
- member since: 01/02/2008
- rank: 3 of 28504
- 39 articles authored
- 1 blog entries posted
- 83 forum threads started
- 237 comments
December 19, 2011 9:51 AM
Add Your Reply
Sponsored Links
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2011 NETGEAR, Inc. All rights reserved.
