Previous Thread
Proto: TCP/UDP Ext port: 8081 Int port: 8081 Int address: 192.168.1.???
Then hit " Save" and it should work.
Connect with: http://wanip:8081
Categories: Setup/Configuration
Hi, I installed Tomato by Shibby on my Netgear WNR3500Lv2.
I've no problem with connection, but I can't connect my ipcamera, by a public ip(remote).
I made a port forwarding on 8081 port (TCP/UDP), but not work.
Where I wrong?
Thanks for help
July 18, 2012 11:32 AM
updated: July 18, 2012 11:34 AM
July 19, 2012 9:28 AM
updated: July 20, 2012 12:56 PM
Okey, there is a lateset one 097 if you wan't upgrade. Don't forget to do a NVRAM reset before and after upgrading.
Make sure you using static ip for your portforwarding.
Ehm can you connect inside your LAN then ?
I'm using PF and have no problem. Don't know why not working for you.
kthaddock
September 25, 2012 3:03 AM
Hi, i've the same problem. Something is wrong with port forwarding in this tomato. After many, many tests and restarts, hard resets, clearing nvram one range of ports is working, but others still no.
Add Your Reply
Sponsored Links
Copyright © 2013
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
My Open Router |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community
MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2011 NETGEAR, Inc. All rights reserved.
