R6200/R6200v2 Smart WiFi Router

Need help a copy cfe.bin

My R6200v1 accident brick on setup. Serial output just hang in there:

Decompressing..........done
Decompressing..........done

CFE for R6200 version: v1.0.1
Build Date: Fri May 11 13:46:43 CST 2012
Init Arena
Init Devs.
Boot partition size = 262144(0x40000)
Found an ST compatible serial flash with 256 64KB blocks; total size 16MB
CPU type 0x19740: 480MHz
Tot mem: 131072 KBytes

All ethernet port not work. I guest cfe partition corrupt. Anybody can dump cfe for me ? Pls help.

Does the R6200 firmware have the ADSL2+ capabilities for the D6200?

AS the title says above.

 

The only difference between the R6200 and the D6200 is the ADSL support and I'm wondering if this supports it or not?

 

Thanks,

Sup3rlativ3

Debricking a Netgear D6200

I have a Netgear D6200 WiFi DSL Modem Router (http://www.netgear.com/home/products/networking/dsl-modems-routers/d6200...)

After a power surge, the router has stoped working and now shows a continuously flashing amber light when powered on. 

DD-wrt vs netgear firmware

Hi,

Just test the build form june of dd-wrt and in comparison teh wifi signal is really bad.... nedd to test it more, but with original firmware it televison via wifi is just runnig smooth, with ddwrt no chance...

 

Any tips what i can change in ddwrt that i get the smae signalrange and powr?

 

cubii

R6200v2 config

Hi,

Can you all help me configuring my R6200v2 router with DD-WRT? I had a Linksys 160N for some years and it was fully tunned, but now I can't, or I don't know how to, make higher channels (+100) to appear. I think that it's the reason why connection speed don't achieve more than 400mbps compared  to 866 when using original firmware. I  tried to configure using fixed AC or 5gz, 40 or 80mhz, but nothing worked.

 

Anther question is about setting router's mW power. Can I set all the 700mW that had been stated by Netgear in the product box?

 

Thank you.

Adding R6200v1 support to OpenWrt

Hi there,

 

I'm attempting to add the Netgear R6200v1 to OpenWrt's list of supported devices, but am having a bit of trouble getting started. I've successfully downloaded and built the OpenWrt source code for the Broadcom BCM47XX devices, but unfortunately the R6200 doesn't appear in the list of generated devices.

I'm a relative Newb to this sort of development, so any pointers would be greatfully received!

TIA.

Develop Firmware

Is anyone going to develop the firmware for this model?