Build 23350 15. Jan 2014.

7 posts / 0 new
Last post
Accid
Accid's picture
Build 23350 15. Jan 2014.

These are the features I have tested and are using

Vlans working

QOS working

Wireless 2.4 will work at full speeds only if Beamforming is disabled, if enabled the speed is limited to 2 – 2.5mbps

WDS is working when linked with a Linksys E900

Keep Alive - Schedule Reboot working

Universal Plug and Play (UPnP) working

USB Support on both ports working (had to reboot router) testing the read right speeds

Samba Server working so far

Kong
Kong's picture
In my tests I also had

In my tests I also had problems with wireless performance with beamforming enabled along with an Intel 6300 agn.

With the other wireless clients I tested e.g. Netgear A6200, beamforming works well.

I also got reports from others, that the the Intel 6250 shows the same behaviour. So far I only know of problems with Intel Adapters and wireless.

octogon
octogon's picture
Accid said:

Accid said:

These are the features I have tested and are using Vlans working QOS working Wireless 2.4 will work at full speeds only if Beamforming is disabled, if enabled the speed is limited to 2 – 2.5mbps WDS is working when linked with a Linksys E900 Keep Alive - Schedule Reboot working Universal Plug and Play (UPnP) working USB Support on both ports working (had to reboot router) testing the read right speeds Samba Server working so far

Hi , where can i download the latest firmware for Newtgear R7000 , build 23350, thanks in advance.

Subhra
Subhra's picture
First use the Initial flash

First use the Initial flash for R7000 and then Build 23350

Accid
Accid's picture
I have noticed the Linksys

I have noticed the Linksys E900 freezing, I have had to set the automatic reboot time on the E900 to 2 hours.
I have tested the copy speed on the network while connected to the Linksys E900 on WDS, its under a megabyte. Have to try it when connected to the R7000 only.
My wireless is set to NG, channel 4 and 20.
The read write speeds from a USB 3 hard drive are between 20-29 Mbps, not bad.
Yesterday I noticed I had no wireless access(the devices were not getting an IP)on the BULLET-M2-HP or my private network but I tried it through the wired ports and I had internet.

I think I have to many services running on the device. Will remove and retest.
Along with the services I have listed I have also added access restrictions for a specific MAC address.

pth
pth's picture
I'm currently running (01/03

I'm currently running (01/03/14) kongac - build 23270M. Can I upgrade directly to 23350 using the Firmware Upgrade page?

Kong
Kong's picture
Yes and since there was no

Yes and since there was no change in nvram params you don't need to reset, just flash the new build.