NETGEAR R8000 Nighthawk (Rev 29627) 5GHZ WEP only?

5 posts / 0 new
Last post
incuzzz
NETGEAR R8000 Nighthawk (Rev 29627) 5GHZ WEP only?

Hey, 

 

i just flashed to the current June Rev and nomatter which security Setting i chose on the two 5ghz Bands it only uses WEP :/

Tryed reflash, same issue.

Any ideas?

 

regards

magellat
Same issue here;soft reset

Same issue here;soft reset did fix it;however,cannot connect to 2.4 GHz...on Channel 1,6 or 11,no matter !

imran619
Same issues here i just

Same issues here i just posted on the other section not realising people are experiening the same issue

guess il be downgrading.

 

I was using Dec Firmware.

 

Anyone had issues with OpenVPN issues on DEC firmware?

imran619
Iv gone back to the old

Iv gone back to the old firmware

LordDarlymple
Dec Firmware - ExpressVPN

Dec Firmware - ExpressVPN OpenVPN configuration did not work for me.

With Jun firmware - ExpressVPN configuration did work - like a charm. However, speed is quite slow both on wired and wireless (much higher if directly installed on the laptop).

I finally got the Jun firmware working after doing 'erase nvram' and 'reboot' after the flash. All radios working fine. Earlier the 5 GHz radios were always off and I even if I renamed them, it sitll showed up as ddwrt on wifi networks.