Add ARP entry in Voxel Firmware

7 posts / 0 new
Last post
Tue, 10/16/2018 - 10:03pm
#1
hkjosephng
Add ARP entry in Voxel Firmware

When I tried to use the command "arp -i br0 -s 192.168.1.2 AB:CD:EF:12:34:56" to set the ARP entry, it only gave me the list of ARP entry.

IP address       HW type     Flags       HW address            Mask     Device
192.168.1.131    0x1         0x2         12:34:56:78:07:24     *        br0
123.123.213.1    0x1         0x2         12:23:34:55:9c:e1     *        brwan
192.168.1.10     0x1         0x2         12:23:34:44:62:ba     *        br0
192.168.1.107    0x1         0x2         12:23:34:44:00:7d     *        br0
192.168.1.104    0x1         0x2         12:12:12:ff:f2:c2     *        br0
 

Any idea about how to set the Perm entry to ARP?

 

Thanks!

Top
Sun, 10/21/2018 - 4:01pm
Permalink
kamoj
ARP entries are not permanent

ARP entries are not permanent.

If you want to always keep IP connected to MAC, do it through Address Reservation at:
Netgear GUI, Advanced, Setup, LAN Setup

 

Top
Mon, 10/22/2018 - 3:56am
Permalink
hkjosephng
I want to add an APR Entry

I want to add an APR Entry for Wake on WAN.

Top
Mon, 10/22/2018 - 11:36am
Permalink
kamoj
ip neigh add 192.168.1.2 dev
ip neigh add 192.168.1.2 dev br0 lladdr AB:CD:EF:12:34:56 nud permanent
ip neigh change 192.168.1.2 dev br0 lladdr AB:CD:EF:12:34:56 nud permanent
 
Top
Mon, 10/22/2018 - 11:54am
Permalink
kamoj
Or even better, works at all
Or even better, works at all times without need to test if existing or not:
ip neigh replace 192.168.1.2 dev br0 lladdr AB:CD:EF:12:34:56 nud permanent
 
Ok?
 
Top
Wed, 11/07/2018 - 2:42am
(Reply to #5) Permalink
hkjosephng
It works!  Thanks a lot! 

It works!  Thanks a lot! smiley

Top
Wed, 11/07/2018 - 3:19pm
Permalink
kamoj
Thank you for reporting back!

smiley Thank you for reporting back!

Top