How to set recovery mode (R8000)

5 posts / 0 new
Last post
mcooper6
mcooper6's picture
How to set recovery mode (R8000)

How do I put the Netgear Nighthawk X6 R8000 into recovery mode where TFTP can be used?

quantum
quantum's picture
im trying to figure out the

im trying to figure out the same thing

 

Alex0597
Alex0597's picture
You can’t, but you can

You can’t, but you can telenable it.

Not an expert, but I always get the job done and look good doing it.

mikeloeven
mikeloeven's picture
will telenable work on a

will telenable work on a router with bad / wrong firmware or do you need a serial connection at that point

Alex0597
Alex0597's picture
Serial port will be best on

Serial port will be best on that case.

Not an expert, but I always get the job done and look good doing it.