Multiple ps4 OPEN NAT issue DD-WRT v3.0-r29300M (03/30/16)

6 posts / 0 new
Last post
jhorath
jhorath's picture
Multiple ps4 OPEN NAT issue DD-WRT v3.0-r29300M (03/30/16)

Hello, I have been having issues with getting OPEN nat on multiple PS4s on one LAN. I have been using  R6250 with Kong for a while now and have yet to find a configuration in port forwarding, port range, triggering, UPnP that will give all 3 ps4 OPEN NAT.  I basically settled on cable modem> GS105 switch>(3) R6250 each with it's own WAN IP address. Only 1 Router is cfg'd for DHCP, all wired clients are static, all wifi is DHCP. All DDWRT, R6250 have wifi Disabled.  This was the only way I could get OPEN NAT on all 3 at the same time.  

Today I picked up a sweet deal on a AC1900 Nighthawk and out of box, with stock  R7000-V1.0.4.30_1.1.67.  Low and behold the stock firmware can actually give me OPEN NAT on all 3 ps4s at once. So what's the deal with DD-WRT?  The only features that interest me are DDNS support, QoS bandwidth/MAC, OPEN NAT.  

I can't get all 3 in one router?  I'm open to reasonable suggestions that are not basic.  I have done every combo and rebooted several hundred times and the only way DDWRT is allowing this is with 3 seperate routers. I've 30/30/30 so many times I can't even count.  Every possible scenario Ive thought of, read on the web, everything.  

 

Very frustrated and disappointed to say the least. 

 

 

jhorath
jhorath's picture
Forgot to say that I tested

Forgot to say that I tested the NAT for all 3 ps4s on stock f/w all are OPEN NAT. However when I upgrade to DDWRT for my beloved QoS MAC settings I can gain OPEN NAT except on one at a time. This is an issue because it causes problems with limitations in chats at some points as well as joining in and out of lobbies with each other in full parties. 

jhorath
jhorath's picture
(No subject)

Aid
Aid's picture
I'm still learning about this

I'm still learning about this type of stuff. How do know your NT is not open? What is the NAT on the console in network settings, should be Type 2. Does a game such as BO3 state NAT is moderate? Mine said that and I just opened port UDP for 3074-3074, exited the game and NAT was open

When i check my UPnP settings in the router I don't have else showing like opened ports. Stupid question, but have you opened a port in port forwarding/port triggering settings (click on Add Custome Service)?

These boards are very slow and you'll be lucky to get a reply. Have you seen the number of views on some posts and NO replies!

 

jhorath
jhorath's picture
This is a post about MULTIPLE

This is a post about MULTIPLE consoles on one network. I have NO issue gaining OPEN NAT type for one console.

 

jhorath
jhorath's picture
I guess nevermind. I

I guess nevermind. I reflashed back to stock on all the r6250, R7000 and stock firmware can get the job done. It sucks cause in order to throttle my upload for gaming I throttle the entire network which somehow affects my download as well. It would be nice if basic features worked for out of the norm setups. I'm sure it's just a tweak away from working as good or better than stock but I don;t know who to contact and so far zero help here.