Having some issues with my R7000 with a Kong build on it.
i mistakingly add something to the script and made it execute on boot up, which just made the router go in a loop.
i bought a usb to ttl cable and can see everything, i can get a ping out of the router but only for a couple of seconds then its lost. here is some of the log.
hope someone can help me out! stumped... and looks like i might not be able to recover.
This is with also pressing crtl-c it does not respond.
Boot up from NAND flash...
Bootcode Boot partition size = 524288(0x80000)
DDR Clock: 800 MHz
Info: DDR frequency set from clkfreq=1400,*800*
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 6.37.15.1 (r407936)
CPU type 0x0: 1400MHz
Tot mem: 262144 KBytes
Device eth0: hwaddr C4-04-15-1E-AF-B4, ipaddr 192.168.1.1, mask 255.255.255.0
gateway not set, nameserver not set
Loader:raw Filesys:tftp Dev:eth0 File:192.168.1.2:vmlinuz Options:(null)
Loading: TFTP error 1: File not found or No Access
Failed.
Could not load 192.168.1.2:vmlinuz: Network protocol error
Checking crc...Loader:raw Filesys:raw Dev:nflash0.os File: Options:(null)
Loading: .. 1529456 bytes read
Entry at 0x00008000
Closing network.
Starting program at 0x00008000
Uncompressing Linux... done, booting the kernel.
Bump??/
anyone?
thanks