switch from DD-WRT Kong to Shibby

2 posts / 0 new
Last post
Fri, 07/07/2017 - 7:34pm
#1
laprius
laprius's picture
switch from DD-WRT Kong to Shibby

Hi all,

I notice in the downloads for the Shibby FW it says there needs to be an initial update before dropping the proper payload onto the router. Is this only for a stock FW? Does this still need to be done if the router is switching from DD-WRT?

Cheers

Top
Sun, 07/23/2017 - 1:41am
Permalink
stuffedhaggis
stuffedhaggis's picture
You need to revert to stock.

You need to revert to stock. Then flash the initial FW once this has completed then flash the full AIO Fw,

Top