help bridge wifi, lan & wan - ap mode, internet bband rtr is nat & dhcp

1 post / 0 new
slip4eva
slip4eva's picture
help bridge wifi, lan & wan - ap mode, internet bband rtr is nat & dhcp

Hello,

 

I have been reading up but can't quite figure out what I'm doing. OpenWRT Noob. Any help sincerely appreciated.

I would like:

All one network 192.168.0.0/24, R7800 no DHCP server, no NAT.

Broadband internet router is 192.168.0.1 serving DHCP and doing NAT.

R7800 WAN port connected to Broadband router, gets 192.168.0.0/24 address

Wifi 2.4 and 5 separate ESSID, bridged to R7800, 192.168.0.0/24 addresses

Ethernet machines connected to R7800 switch ports getting assigned 192.168.0.0/24 addresses.

 

Can I bridge Wifi, WAN and all LAN ports together? Disable DHCP server. Somehow turn off NAT (I'm guessing by bridging interfaces). I do not believe I need VLAN config (pardonmy ignorance). I've been reading about Dump AP mode, etc. I can'tfigure exactly what I need to configure for the R7800.

 

CPU (eth0) CPU (eth1) LAN 1 LAN 2 LAN 3 LAN 4 WAN