Hi everyone,
I think i missconfigured my router by setting the following value:
LAN Interface - bridged
Now I can't ping/telnet/ssh the router...
Any suggestions, what I can do to get my router back to life???
I've been trying to 30-30-30 reset the router a couple of time (releasing the reset button after 90 seconds, releasing the reset button after 90 seconds
and pulling the power cord, releasing the reset button after 90 seconds
and switching the power button....)
Do you have any other idea how i can reset the firmware or anything else??
Hope anybody can held me...
Thanks in advance
Bjoern
See the folllowing link.
http://www.dd-wrt.com/wiki/index.php/Hard_reset_or_30/30/30
thx for the link - but it did'nt worked (neither with the reset- nor with the WPS- Button...
The major problem is, that the system is running fine - but i actually cant access it, because the lan-interface is in bridged mode and doesn't respond to _anything_.
Any other suggestions than using a ttl-based restore???
Bjoern:
Open up a cmd window and start a continuous ping to the router (192.168.X.X). Power off the unit, then plug it back in. If you see any response at all as you plug in power, you may be able to tftp the NETGEAR stock firmware if you time it correctly (may need many tries). See Note 6 of http://www.dd-wrt.com/phpBB2/viewtopic.php?t=51486
If that fails, you need to debrick. See http://www.myopenrouter.com/article/20501/Reset-Debrick-NETGEAR-WNR3500L... (THIS IS RISKY).
Better yet, see
http://www.myopenrouter.com/article/13859/How-To-Debrick-Your-NETGEAR-WN...