(PLEX)Firmware: DD-WRT v3.0-r31085M kongac (01/04/17)

1 post / 0 new
goodyaz
goodyaz's picture
(PLEX)Firmware: DD-WRT v3.0-r31085M kongac (01/04/17)

I am trying to figure out the change on

Firmware: DD-WRT v3.0-r31085M kongac (01/04/17)

I have a huge plex server that people connect to on a daily basis to stream.  I have updated the router software to the above.  Everything is NAT correctly.  I have been doing this for years.  I even QOS 32400 for plex Maximum.  I am getting complaints from clients constantly today saying that they are having issues. 

My computer does a lot of transcoding for these movies/tv shows.   If they can direct play it does that also.  I have had up to 5-6 people at a time watching 1080 videos without a complaint or problem with my Plex server.  It is not the server as I monitor it most of the day.

Please help.   I am going to go back to stock netgear firmware and just normal NAT it back to when I first got this router so long ago.

I can write down specs on what runs on what in my network and I can even draw you a diagram if someone needs it.  I have a good setup and never had the problem until this update. 

V/R

Goodyaz

Zircon - This is a contributing Drupal Theme
Design by WeebPal.