R7800 X4S 2.4Ghz signal quality suffering on Voxel 1.02.59SF

5 posts / 0 new
Last post
Wed, 08/29/2018 - 7:03am
#1
davidm71
davidm71's picture
R7800 X4S 2.4Ghz signal quality suffering on Voxel 1.02.59SF

Hi,

 

Just flashed to Voxels 1.02.59SF and noticed I was having difficulty connecting to the 2.4ghz channel as where I did not before. I also use another Tomato router to analyze the signal quality and its less then my 5 ghz band. Any way to boost the signal with Voxel's firmware?

 

Thanks

Top
Wed, 08/29/2018 - 7:57am
Permalink
e38BimmerFN
e38BimmerFN's picture
Try a factory reset and set

Try a factory reset and set up from scratch?

Load NG Stock FW and compare?

Top
Wed, 08/29/2018 - 8:03am
Permalink
e38BimmerFN
e38BimmerFN's picture
I would post here as well:

I would post here as well:

https://www.snbforums.com/threads/custom-firmware-build-for-r7800-v-1-0-...

Top
Wed, 08/29/2018 - 2:26pm
Permalink
davidm71
davidm71's picture
I actually did end up posting

I actually did end up posting there. I'm sure its a channel interference issue. Just have to find a clean channel to use. 

Surprisingly the 5 ghz channel is coming in much stronger than the 2.4ghz for some reason.

Top
Thu, 08/30/2018 - 1:24am
Permalink
Voxel
Voxel's picture
I do not think that level of

I do not think that level of signal was changed in the stock 1.0.2.58 (I use its changes in my 59SF version). The same QCA drivers. So the level of 2.4 and 5GHz signal should be the same.

Voxel.

Top