I have an single wired network with 2 gateway (2 Box same ISP). I have a DHCP video device associated with each box. The problem is, if one of its devices sees more than one box it disrupts the functioning of both. I cut my network into two Class C by setting a fixed DHCP leases for each device. But this does not fix the problem.
Why two gateways for connection redundancy, on the same wired network so that all computers can inter acted with each other (share files / printers). Geographically the two boxes are not in the same room behind a chain switch (unmanaged).
I want block the two ARP adress for access to the other box on each side. Set router in the middle.
All i see is WAN/LAN filtering, how setup LAN/LAN filtering?
Video1 --- Box1 --- WNR300Lv2 --- Box2 --- Video2
Computer1 / \ Computeur2
How setup WNR300Lv2 for :
Boxes and Computers in same class C.
All computers FULL ACCESS to ANY computers/boxes with ANY protocol/port.
Video1 ACCESS DENY to Box2.
Video2 ACCESS DENY to Box1.
Video1 FULL ACCESS to Box1 with ANY protocol/port.
Video2 FULL ACCESS to Box2 with ANY protocol/port.
More understanable?
I can use functionality of WNR300LV2 with the last Tomato firmware, for setup rules/vlans/routes for apply an bridge between Box1 and Box2 for exclude Video1 and Video2 to pass through the WNR300Lv2.