Seperating Wireless from Wired using DD-WRT and an R7000

4 posts / 0 new
Last post
phoomanchew
phoomanchew's picture
Seperating Wireless from Wired using DD-WRT and an R7000

Hello,

I have a R7000.  I would like to seperate the Wireless network from the Wired.  I do not want my wireless devices to have access to any of my wired devices.  I have read various articles and nothing seems to work correctly. 

I have tried latest versions of both the Kong Mod and DD-WRT version with no luck. 

Any guidance would be appreciated.

 

Thanks!

phoomanchew
phoomanchew's picture
Nothing?  Anything?

Nothing?  Anything?frown

phoomanchew
phoomanchew's picture
Okay, I believe I figured it

Okay, I believe I figured it out on my own.  Now I would like some feedback on if what I did was correct.  These settings seem to isolate my wired connections from my wireless connections.  Any feedback would be appreciated.

Go to the Setup->Networking tab

  • Under Port Setup, modify Network Configuration for eth1 or whatever your wireless is.
    • Set Bridge Assignment to Unbridged
    • Set Net Isolation to Enable
  • Under DHCPD, add a new DHCP server for eth1
    • DHCP1     eth1     On     Start     100     50     3600

Go to the Wireless tab

  • Under Wireless Physical Interface wl0
    • Set Wireless SSID Broadcast to Enable
    • Observe that Network Configuration should be set to Unbridged
    • Observe that Net Isolation should be set to Enable

Go to the Wireless->Wireless Security tab

  • Set Security Mode to WPA2 Personal
  • Set WPA Algorithms to AES
  • Set your WPA Shared Key to a very good password

Go to the Wireless->WLO-Advanced tab

Change AP Isolation to Enable

phoomanchew
phoomanchew's picture
Maybe this is not the correct

Maybe this is not the correct place to post this question.  Can someone please tell me where I can post this to get some feedback?  Thanks.smiley