Hello everyone. I am new to modding range extenders and routers. Here is what I am trying to do. I want to take my EX6200 use it in my RV to connect to various wireless networks. I have other devices connected (Wired & wireless) to my EX6200. I want to be able to connect or enter the password as required to gain access to the main router and then have access for all components connected to my EX6200. Is this possible and what settings would I need to make it work. I have already flashed my extender with the current DD-WRT file for it. Any info will be greatly appreciated.
Regards
Todd
I'm sorry! I don't understand English.
Well after several attempts to get the settings correct I thought I may of had an old version of firmware. So I downloaded a version from a ftp betas2015 for ex6200 when I flashed this firmware all was looking good. However the extender now just continues to cycle through the power up sequence. I am assuming this is what everyone refers to as Bricked?
You can remove the flash programmer writes
检测到输入为:英语
I use the original firmware backup programmer
How can I do this ? Is there a link to a how to post?