EX6200 setup

7 posts / 0 new
Last post
Wrenches
Wrenches's picture
EX6200 setup

Hello everyone. I am new to modding range extenders and routers. Here is what I am trying to do. I want to take my EX6200 use it in my RV to connect to various wireless networks. I have other devices connected (Wired & wireless) to my EX6200. I want to be able to connect or enter the password as required to gain access to the main router and then have access for all components connected to my EX6200. Is this possible and what settings would I need to make it work. I have already flashed my extender with the current DD-WRT file for it. Any info will be greatly appreciated. 

 

Regards 

Todd

cysaty
cysaty's picture
 

 

I'm sorry! I don't understand English.

123456

Wrenches
Wrenches's picture
Well after several attempts

Well after several attempts to get the settings correct I thought I may of had an old version of firmware. So I downloaded a version from a ftp betas2015 for ex6200 when I flashed this firmware all was looking good. However the extender now just continues to cycle through the power up sequence. I am assuming this is what everyone refers to as Bricked?

cysaty
cysaty's picture
 

 

You can remove the flash programmer writes

123456

cysaty
cysaty's picture
 

 

 

 

I use the original firmware backup programmer

123456

Wrenches
Wrenches's picture
How can I do this ? Is there

How can I do this ? Is there a link to a how to post? 

 

cysaty
cysaty's picture
 

 

不好意思 跟你对话很费劲 因为我对英文懂得不多 用翻译软件 翻译后很多语言 不是原来的意思了

123456