My home network setup goes like this: Alice router (router/modem) and one of its uplinks running to my Netgear WNDR3400v2 running DD-WRT v24-sp2 to its WAN uplink. My Alice box is running the DHCP service while my Netgear is in AP mode however, when in AP mode the feature to run a dynamic service disables. So I flashed my Netgear with dd WRT and can't seem to figure out if I can run my NG in some non-DHCP mode, receive its IP addressing from the Alice router/modem all while running the Dynamic DNS service. Any thoughts?
Develop your Cybersecurity Framework
Supply chain attacks, ransomware attacks, phishing, data breaches; all these types of attacks are on the rise, thanks to the expansion of the connected world. With greater expansion comes greater security risk.Recent comments
- I think the R8000 firmware 1 week 13 hours ago
- Just want to add some update: 1 week 2 days ago
- When I press Ctrl+C, the boot 1 week 2 days ago
- Well, Netgear has the 1 week 4 days ago
- waste of time 1 month 3 weeks ago
Hi
Why go through the trouble.
can you set your Alice router (router/modem) as a bridge and use your Netgear router to handle all services.
Well the Alice router is all in German and you can't change the language. It has PPPoE setting and I understabd if I turn that off its in bridge mode?
Hi
Why go through the trouble.
can you set your Alice router (router/modem) as a bridge and use your Netgear router to handle all services.
Well the Alice router is all in German and you can't change the language. It has PPPoE setting and I understabd if I turn that off its in bridge mode?