MyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2020 All rights reserved.
I need the Serial Pin arangement for the X6S internal board. I can't get the thing to accept new firmware because it's stuck in a startup/reboot loupe thanks to NETGEAR Tech suport.
Photos of the internal board are on the NETGEAR Forun, but I guess you need a login to see them https://community.netgear.com/t5/Nighthawk-WiFi-Routers/Netgear-Nighthaw...
I want to try this (https://www.myopenrouter.com/article/how-set-serial-console-netgear-r8000)
to correct the problem. Can I assume that the pin readout would be the below?
(1)-
(2)-GND
(3)-Tx
(4)-Rx
Has anyone started a fofundme for the donations for R8000P support? I think a lot of people invested in this router and it would be a shame to leave it with the stock firmware.
Pages