Partial initial flash

2 posts / 0 new
Last post
kmerrick
kmerrick's picture
Partial initial flash

Not sure how but I am stuck a the initial tomato firmware with no options to go further.

 

Scenario:

Running Advanced Tomato, flashed back to ofw (all is well), upgraded genie then flashed tomato-R7000-initial.chk

Now i am stuck.  I can telnet and winscp but can not successfully tftp or tftp2 (from netgear site).  Can I manually send the firmware over via WinSCP and continue somehow?  

 

 

I can't post images .... so this is the best I can do. The config page is clickable but nothing can be done Save/Cancel.  

 

 

!! Attention !!
You did not configure TomatoAnon project setting. 
Please go to TomatoAnon configuration page and make a choice.

 

System (hide)
 
 
WAN (hide)
   
LAN (hide)
kmerrick
kmerrick's picture
Was able to SCP the R7000

Was able to SCP the R7000-back-to-ofw.trx and flash via telnet

mtd-write2 R7000-back-to-ofw.trx linux <return>

mtd-erase2 nvram <return>

reboot <return>

go into Genie, clear defaults then start process of Tomato install from scratch.  Absolutely NO luck with tftp

Zircon - This is a contributing Drupal Theme
Design by WeebPal.