problem with router switch

3 posts / 0 new
Last post
gearusernet
gearusernet's picture
problem with router switch

Hi

it seems that my router no longer detects the connection of the rj45 cable ... the internet led which detects the internet connection no longer lights up and the integrated switch leds 1 2 3 4 no longer light up. I have the kong ddwrt firmware. Do you think I can catch up? should i try to do a factory update with the original netgear firmware to fix the problem or my hardware is down? the administration interface remains accessible only in wifi. telnet also works ...

 

Thank's in advance

gearusernet
gearusernet's picture
in fact, The internet entry

in fact, The internet entry is not detected and the 4 switch outputs seem to be also inactive ... yesterday everything worked ...

pihole
pihole's picture
Hi, I have the same problem

Hi, I have the same problem with my netgear switch 308t using the new openwrt firmware. So there was 2 options to upload the firmware to, file 1 and 2. I used 1. Not sure if that has anything to do with it. In 108t version which is basically the same with 4 ports, says you need to be on vlan 100. I've done that maybe wrong but hasn't worked. 

 

I literally have the same issue as you, later I will check if its a power issue when I have time. You need to serial consol that. Anyways let me know if you fixed it or watch my thread as I will update it. 
https://forum.openwrt.org/t/netgear-gs308t-v1-bricked-snapshot/97917

theres anotehr 308t thread, watch that too. Hope you find a fix so everyone else can learn off it. Thanks and take care, stay tuned for serial soldering I'll give it an attempt tomorrow maybe